When a light gray or reddish brown, you take it easy because it means the engine is in good condition that fit the condition of the engine, ignition timing and engine settings.
When the end of the insulator, electrodes and spark plugs covered with black soot and combustion smooth and dry, you should immediately check the choke mechanism, the air filter and replace spark plugs if necessary. The possibility exists that does not fit with the spare parts. If ignored it will be wasteful fuel consumption, black smoke and difficult to start when engine cold.
Color slightly yellow edge insulation may appear light brown and green color usually indicates the possibility of gasoline or oil contaminated water or additives are less suitable. As a result, sluggish engine, slowly accelerates, breathing hard and explosive exhaust.
So be more frequent cleaning and caring for spark plugs. Since the spark plugs will support machine-groomed to work well. Clean the spark plug every 2500 km and have it replaced when it has covered 20 000 km
This means that drivers no longer have tired of stepping on the clutch to shift gears. On cars with manual transmission, to shift gears, the clutch must be pressed.
Another fact, of all the control systems should be operated driver’s car, the clutch is the most energy-consuming. In addition, the level of operation is also very high, especially when traffic jams or solid creep!
Easy out
Nevertheless, it turns out there are still many among us who still assume negative effect on the automatic transmission. It is also recognized by auto manufacturers. For example, if the strike, cars with automatic transmission can not be encouraged. If is often used in mountainous areas, brake quickly exhausted.
All the assumptions of the past. Now, more and more automatic transmission, the manufacturer provides the mechanics who have the ability to fix it faster if there is a problem. In fact, now there is also a general workshops that could deplete the entire automatic transmission fluid (ATF) in the transmission and then filled with a lubricant that really new and clean.
In the car now, especially the use of injection systems, when the battery is weak, then the machine will not start. Because the engine computer to get energy from the battery. Therefore, the position of manual and automatic transmissions the same!
Then, on the assumption that the automatic braking when the car drove lavishly in areas with many derivatives, ascertained, that the condition occurred because the driver was too relaxed, allowing the transmission to position “D” course. In fact, D is the highest gear.
Keep working
To reduce the workload of the brakes, the driver must use engine brake effect by using a lower gear. In this case, it could be “two” or if more steep and slippery, should be “L”. Same with low teeth, 3 or 2 on the manual transmission. As for acceleration, the driver should kick or step on the gas pedal down fast!
So, driving with automatic transmission that does not mean the hand does not work at all. At a certain field conditions, 3, 2, and L should be used. Hand still be active. Only the left foot is completely relaxed. No need to stampede the clutch at all. For example when the streets are declining or accelerated during the ascent!
In fact, the bad conditions, by releasing the brake pedal and transmission at the position “D”, the car can crawl without having to hit the brakes.
If you already taste the delicious automatic transmission, especially for those who drive themselves, often through a traffic jam, and have high mobility, they certainly will not want to go back to manual if you do not have to. In fact, they are willing to spend additional costs, both for the transmission of more expensive fuel consumption plus a little more than manual
In driving, there is the term “understeer” and “oversteer”. Maybe you have or have often heard these two words. Just like what the symptoms of a vehicle, perhaps you have not experienced it. Or if ever, perhaps because you do not feel it does not know which one over, which is under.
Well, to understand it, can see the explanation below. Also, how to cope when experiencing.
Understeer
Symptoms tend to car straight, although the steering has been deflected. Commonly known as skid traction because the front is missing. If this was a panic-drivers-especially large potential for harm because the car out of the road.
How to cope :
1. Immediately slowed until traction vehicle back.
2. Do not add spin the wheel, or brakes.
3. Cut down on the accelerator gradually.
4. Reduce the steering wheel rotation.
Oversteer
The opposite of understeer, the rear tires lose grip. Consequently, the stern of the car to shift or twist.
The cause, most commonly we do braking when turning. At that time, the weight moves forward so that makes the rear tires less grip on power. Another factor for turning the steering wheel abruptly.
The danger, the car can be out of control and collided with something from the side. Meanwhile, the sides are not protected as well as front or rear.
How to cope :
1. Do not brake.
2. Do not move the position of the hands on the steering wheel.
3. Make a counter-steering or “reply to” steering wheel with alacrity, but not excessive.
4. Cut down on the accelerator (for rear wheel drive car).
5. Add just enough pressure on the gas pedal (for the front wheels moving car).
6. Move your eyes to the point of going to the intended
7. Be prepared to return the wheel to its original position
One vehicle accident caused by brake free from tension and this has grabbed a lot of casualties. Then how to solve it?
If you are driving and braking suddenly relieved, the first done is do not panic and emotional control.
Then slowly reduce the speed of the vehicle. Then move your foot from the accelerator and then immediately enable the handbrake.
Try to lift the hand brake lever slowly but surely to the optimal.
Do not ever lift the handbrake lever up. Because if you do sudden braking, it could be the rear of the vehicle you are experiencing sudden traction.
If that happens, your vehicle can twist and upside down. Obviously this is very dangerous. Besides, can also use the engine brake or braking through change the gear of the transmission.
Although normally, very difficult to move the transmission from five to one position. But this can be enforced because it is in a state of emergency. Lives are more important than the damage your car engine.
Rain and intense heat usually become the main enemy of rubbers in the car.
Components that include rubber wiper, doors, hood, glass edging, and much more. When it comes to neglected,the potential becomes painfully annoying when driving.
In order elasticity and suppleness awake, spray containing silicone fluid, at least once a month.
Follow these steps to maintain.
• Prepare tools and equipment such as wet and dry cloth, brush, moisturizing liquids containing silicone rubber.
• Clean the surface first and the surrounding rubber.
• Besides the cloth, use a brush to clean the dust that was still attached.
• Spray containing silicone rubber all over evenly.
• Another way is to spray into the sponge. Next apply a liquid rubber component was washed over the target.
• Allow for a moment and make sure the liquid is absorbed into the rubber.
• The rubber components are ready to appear fresher.
Remember, this step is a component of prevention in order to function until the rubber was not damaged. The steps above do not apply for a broken rubber.
